Chery QQ Service Manual
9. Coat a layer of base paint G on the
contact surface of windshield
base paint G
（1） Coat a layer of base paint G with brush
or sponge on windshield periphery and
joint surface
（2） Clear base paint with a clean rag
before drying
Attention：
（1）Leave base paint layer dry for 3 minutes at least
（2）No coating on bonding agent
（3）Never reserve unsealed base paint G for later use
10. Mix bonding agent
Attention：
A. Ensure the fixation of inlaid strip to
finish within the applicable duration
of bonding agent
B. Mixing bonding agent must be
completed within 5 minutes
- 262 – Chery Automobile Co.,Ltd
（1） Clean glass plate and oil loam scraper
thoroughly with solvent
(2 ) Fully mix 500g principal agent with
75g hardening agent with scraper on
glass plate or similar object
11. Apply bonding agent
（1）Cut off the Note of tubular pot and fill
bonding agent in the pot
（2）Put the pot into sealing glue gun
（3）Apply bonding agent on windshield
as showed in the drawing
10mm (0.39in)
To Next Page
Loading...
