Chery QQ Service Manual
Never reserve unsealed base paint G for later use
8. Mix bonding agent
Attention：Ensure the fixation of inlaid strip
to finish within the applicable duration of
bonding agent
Mixing bonding agent must be completed
within 5 minutes
Clean glass plate and oil loam scraper
thoroughly with solvent
Fully mix 500g principal agent with 75g hardening agent with scraper
on glass plate or similar object
9. Applying bonding agent
Cut off the tip of tubular pot and fill bonding
agent in the pot
Put the pot into sealing glue gun
Apply bonding agent on glass as showed
in the drawing
10.Install glass
When installing windshield, align the
reference marks on glass and car body, then
gently press in glass towards periphery
Smear glass at periphery with bonding agent
using scraper
Remove excess or spilled bonding agent with scraper
Fasten glass until bonding agent hardened
11. Water leakage checking and maintenance
Water leakage test shall be conducted after curing time
Block up water leaking places with sealant
- 268 – Chery Automobile Co.,Ltd
To Next Page
Loading...
