B-4
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Appendix B QoS Policy Propagation Through the Border Gateway Protocol
Related Documentation
Match prefix 70 and set community to 60:7.
RouterB(config)# route-map send_community permit 70
RouterB(config-route-ma)# match ip address 70
RouterB(config-route-ma)# set community 60:7
For all others, set community to 60:8.
RouterB(config)# route-map send_community permit 80
RouterB(config-route-ma)# set community 60:8
Define the access control lists.
RouterB(config)# access-list 10 permit 61.0.0.0
RouterB(config)# access-list 20 permit 62.0.0.0
RouterB(config)# access-list 30 permit 63.0.0.0
RouterB(config)# access-list 40 permit 64.0.0.0
RouterB(config)# access-list 50 permit 65.0.0.0
RouterB(config)# access-list 60 permit 66.0.0.0
RouterB(config)# access-list 70 permit 67.0.0.0
The following example shows how to configure several interfaces to classify packets based on the IP
precedence and QoS group ID:
interface serial 5/0/0/1:0
ip address 200.28.38.2 255.255.255.0
bgp-policy source ip-prec-map
no ip mroute-cache
no cdp enable
frame-relay interface-dlci 20 IETF
interface serial 6/0/0/1:0
ip address 200.28.28.2 255.255.255.0
bgp-policy source ip-qos-group
no ip mroute-cache
no cdp enable
frame-relay interface-dlci 20 IETF
Related Documentation
This section provides hyperlinks to additional Cisco documentation for the features discussed in this
chapter. To display the documentation, click the document title or a section of the document highlighted
in blue. When appropriate, paths to applicable sections are listed below the documentation title.
Feature Related Documentation
QoS Policy Propagation through Border Gateway
Protocol (QPPB)
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Part 1: Classification > Classification Overview > QoS Policy
Propagation via Border Gateway Protocol
Part 1: Classification > Configuring QoS Policy Propagation via
Border Gateway Protocol
To Next Page
Loading...
Need help?
General
