Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Contents
Cisco Small Business SFE/SGE Managed Switches Administration Guide 3
Defining DHCP Snooping Properties 128
Defining DHCP Snooping on VLANs 129
Defining Trusted Interfaces 130
Binding Addresses to the DHCP Snooping Database 132
Defining IP Source Guard 135
Defining Dynamic ARP Inspection 141
Defining ARP Inspection Properties 142
Defining ARP Inspection Trusted Interfaces 144
Defining ARP Inspection List 146
Assigning ARP Inspection VLAN Settings 148
Chapter 5: Configuring Ports 151
Configuring Ports Settings for Layer 2 Enabled Devices 151
Configuring Ports Settings for Layer 3 Enabled Devices 157
157
Chapter 6: Configuring VLANs 163
Defining VLAN Properties 164
Modifying VLANs 166
Defining VLAN Membership 167
Modifying VLAN Membership 169
Assigning Ports to Multiple VLANs 170
Defining GVRP Settings 173
Modifying GVRP Settings 174
Defining VLAN Interface Settings 176
Modifying VLAN Interface Settings 178
Defining Customer VLANs Using QinQ 180
Defining Multicast TV VLAN 181
Defining CPE VLAN Mapping 183
Defining Protocol Groups 184
Defining a Protocol Port 187

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x