Configuring Device Security
Defining Access Methods
Cisco Small Business SFE/SGE Managed Switches Administration Guide 67
4
-
Te l n e t
— Assigns Telnet access to the rule. If selected, users accessing
the device using Telnet meeting access profile criteria are permitted or
denied access to the device.
-
SNMP
— Assigns SNMP access to the rule. If selected, users accessing
the device using SNMP meeting access profile criteria are permitted or
denied access to the device.
-
HTTP
— Assigns HTTP access to the rule. If selected, users accessing
the device using HTTP meeting access profile criteria are permitted or
denied access to the device.
-
Secure HTTP (SSL)
— Assigns HTTPS access to the rule. If selected,
users accessing the device using HTTPS meeting access profile criteria
are permitted or denied access to the device.
-
Secure Telnet (SSH)
— Assigns SSH access to the rule. If selected,
users accessing the device using Telnet meeting access profile criteria
are permitted or denied access to the device.
• Source IP Address — Defines the interface source IP address to which the rule
applies.
• Prefix Length — Defines the number of bits that comprise the source IP
address prefix, or the network mask of the source IP address.
• Action — Defines the action attached to the rule. The possible field values are:
-
Permit
— Permits access to the device.
-
Deny
— Denies access to the device. This is the default.
Adding Profile Rules
STEP 2 Click the Add button. The
Add Profile Rule Page
opens:
To Next Page
Loading...
