System 3505 Installation & Operation Manual
Digitize, Inc. 700248-0002 Rev. C 02/16
Specification Subject to Change Without Notice
7-22
LINE 2 OK
DATA LOSS
PNL TBL 24 HR
FIRE DRILL
DRILL RSTR
NO BATTERY
BAT PRESENT
NAC #1 FAULT
NAC #1 RSTR
NAC #2 FAULT
NAC #2 RSTR
COMM TBL PRT
COMM PR1 OK
COMM TBL SEC
COMM SEC OK
ANNUN FAULT
ANNUN NOW OK
SYS OFF NRML
SYS NOW NRML
Refer to Appendix F for Contact ID
The DDI-9/10E connects to the telephone line by means of a standard jack (USOC RJ11
C or USOC RJ45 S). Connection to telephone company coin operated service (central
office implemented system) is prohibited. Connection to party line service is subject to
State tariffs.
The telephone company can make changes to their lines, equipment, operations or
procedures that could affect service or the operation of the equipment. The telephone
company will typically provide advance notice to allow facilities to make any changes
necessary to maintain uninterrupted service. Contact the telephone company for any
additional questions related to the telephone line (such as how many pieces of equipment
can connect to it).
Upon request of the telephone company, provide the FCC registration number and the
ringer equivalence number (REN) of the equipment that is connected to the line. Both of
these items are listed on the equipment label. The sum of all the RENs on the telephone
lines should be less than five in order to ensure proper service from the telephone
company. In some cases, a total of five may not be usable on a given line.
If any portion of the telephone equipment is not operating properly, remove it
immediately remove it from the telephone line, as it may cause harm to the telephone
network. If the telephone company notes a problem, they may temporarily disconnect
To Next Page
Loading...
