System 3505 Installation & Operation Manual
Digitize, Inc. 700248-0002 Rev. C 02/16
Specification Subject to Change Without Notice
6-10
6.4.5
Taking a Zone Temporarily Out of Service
If a particular zone is known to have problems, and continues to come in as
TROUBLE or ALARM, it can be taken out of service until the problem is
corrected. A zone can be taken out of service before it is ACKnowledged by
using the IN/OUT SERVICE button. To take a zone out of service, enter the
number of the zone via the upper keyboard, and then momentarily press the
ZONE LOOKUP, and then the IN/OUT SERVICE button. The IN/OUT
SERVICE button may require a password. Enter the password. The printer will
print the words OUT OF SERVICE, along with the zone temporarily out of
service. It will still be displayed on the screen and OUT OF SERVICE will
appear on the left of the display. The zone status will be displayed in small type
just below OUT OF SERVICE.
To put a zone back into service, enter the zone number again via the upper
keyboard, and press ZONE LOOKUP, and then IN/OUT SERVICE
momentarily. The printer will print the particular zone, including the date and
time when it was put back into service. Press the scroll button to put the zone on
the display and then put it back in service by simply pressing the IN/OUT
SERVICE button.
6.4.6
Removing a Digital Dialer from Service
If a particular dialer message is known to have problems, and continues to come
in as TROUBLE or ALARM, it can be taken out of service temporarily. Simply
press IN/OUT SERVICE in place of ACK when the dialer is received (or press
IN/OUT SERVICE when the desired dialer is on the display). Alternatively,
enter the number of the dialer, including the message number.
To remove a total dialer via the upper keyboard, enter “0” (zero) message
number for the dialer to be taken out and then momentarily press Dialer Lookup;
press IN/OUT SERVICE. The printer will print the words ‘‘OUT OF
SERVICE,’’ along with the identification of the dialer that is out of service. It
will still be displayed on the screen, and OUT OF SERVICE will appear on the
display.
To put a DIALER back into service, press IN/OUT SERVICE when that dialer
appears on the screen. Alternatively, enter the DIALER AND MESSAGE
NUMBER, or a ‘‘0’’ (zero) for a total dialer, again via the upper keyboard, and
press DIALER LOOKUP, and then IN/OUT SERVICE momentarily. The
printer will print the identification of the dialer, including the date and time when
it was put back into service.
6.4.7
Initiating Status Printout for Non-Secure Zones
Press SHIFT, then STATUS (or the STATUS PRINTOUT button) momentarily
to cause the printer to print the status of all zones, dialers, boxes and system
errors which are NOT in a secure condition, or which are out of service.
6.4.8
Checking Status/Message of Individual Zone
To quickly find out the status of a particular zone, enter the zone number on the
upper keyboard, then depress and hold the ZONE LOOK UP button. As long as
this button is held the particular zone will be displayed on the screen. The
To Next Page
Loading...
