F 52 10
Oil change:
A
Change the oil when the engine is at operating temperature.
A
Oil change < / = s/n XXXX
- Place the end of the oil drain port hose
(C) in the collection container.
- Remove the screw cap with a wrench
and allow the oil to drain completely.
- Replace the screw cap and tighten
properly.
- Fill in the specified quality of oil
through the filler opening (B) on the
engine until the oil level rises to the
correct mark on the sensor rod (A).
A
Oil change > / = s/n XXXX
- Unscrew seal cap (C).
- Screwing on the oil drainage hose (D)
opens the valve to let the oil drain out.
- Place the end of the hose in the col-
lecting vessel and let the oil drain com-
pletely.
- Unscrew the drainage hose and return
the screw cap.
To Next Page
Loading...