F 52 11
Changing the oil filter:
A
All filters are accessed via the service flap (F) on the vehicle's centre wall:
- Remove the screws (G) from the inner
side of the frame and remove the serv-
ice flap (F).
- After completing the maintenance
work, reinstall the service flap (F)
properly.
A
The new filter is inserted during an oil
change once the used oil has been
drained out.
- Loosen the filter (H) with a filter
wrench or filter strap and unscrew it.
Clean the contact surface.
- Apply light coating of oil to the gasket
on the new filter and fill filter with oil
before installing it.
- Tighten filter by hand.
A
After installing the oil filter, attention
must be paid to the oil pressure display
and good sealing during the test run.
Check oil level again.
To Next Page
Loading...