Chapter 30
| Multicast Routing Commands
PIM Multicast Routing
– 1031 –
Example
Console#show ip pim interface vlan 1
PIM is enabled.
VLAN 1 is up.
PIM Mode : Dense Mode
IP Address : 192.168.0.2
Hello Interval : 30 sec
Hello HoldTime : 105 sec
Triggered Hello Delay : 5 sec
Join/Prune Holdtime : 210 sec
Lan Prune Delay : Disabled
Propagation Delay : 500 ms
Override Interval : 2500 ms
Graft Retry Interval : 3 sec
Max Graft Retries : 3
State Refresh Ori Int : 60 sec
Console#
show ip pim neighbor This command displays information about PIM neighbors.
Syntax
show ip pim neighbor [interface vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
Displays information for all known PIM neighbors.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show ip pim neighbor
Neighbor Address VLAN Interface Uptime (sec.) Expiration Time (sec) DR
---------------- -------------- ------------- --------------------- ---
192.168.0.3/32 1 00:00:21 00:01:30
Console#
Table 201: show ip pim neighbor - display description
Field Description
Neighbor Address
IP address of the next-hop router.
VLAN Interface
Interface number that is attached to this neighbor.
Uptime
The duration this entry has been active.
To Next Page
Loading...
