Chapter 27
| IP Interface Commands
ND Snooping
– 788 –
clear ipv6 nd
snooping prefix
This command clears all entries in the address prefix table.
Syntax
clear ipv6 nd snooping prefix [interface vlan vlan-id]
vlan-id - VLAN ID. (Range: 1-4094)
Command Mode
Privileged Exec
Example
Console#clear ipv6 nd snooping prefix
Console#show ipv6 nd snooping prefix
Prefix entry timeout: (seconds)
Prefix Len Valid-Time Expire VLAN Interface
-------------------------------------- --- ---------- ---------- ---- ---------
Console#
show ipv6 nd
snooping
This command shows the configuration settings for ND snooping.
Syntax
show ipv6 nd snooping
Command Mode
Privileged Exec
Example
Console#show ipv6 nd snooping
Global ND Snooping status: enabled
ND Snooping auto-detection: disabled
ND Snooping auto-detection retransmit count: 3
ND Snooping auto-detection retransmit interval: 1 (second)
ND Snooping is configured on the following VLANs:
VLAN 1,
Interface Trusted Max-binding
--------- --------- -----------
Eth 1/1 Yes 1
Eth 1/2 No 5
Eth 1/3 No 5
Eth 1/4 No 5
Eth 1/5 No 5
.
.
.
show ipv6 nd
snooping binding
This command shows all entries in the dynamic user binding table.
Syntax
show ipv6 nd snooping binding
To Next Page
Loading...
Need help?
General