Chapter 22
| Multicast Filtering Commands
IGMP Snooping
– 585 –
ip igmp snooping
proxy-reporting
This command enables IGMP Snooping with Proxy Reporting. Use the no form to
restore the default setting.
Syntax
[no] ip igmp snooping proxy-reporting
ip igmp snooping vlan vlan-id proxy-reporting {enable | disable}
no ip igmp snooping vlan vlan-id proxy-reporting -
vlan-id - VLAN ID (Range: 1-4094)
enable - Enable on the specified VLAN.
disable - Disable on the specified VLAN.
Default Setting
Global: Enabled
VLAN: Based on global setting
Command Mode
Global Configuration
Command Usage
◆ When proxy reporting is enabled with this command, the switch performs
“IGMP Snooping with Proxy Reporting” (as defined in DSL Forum TR-101, April
2006), including last leave, and query suppression. Last leave sends out a proxy
query when the last member leaves a multicast group, and query suppression
means that specific queries are not forwarded from an upstream multicast
router to hosts downstream from this device.
◆ If the IGMP proxy reporting is configured on a VLAN, this setting takes
precedence over the global configuration.
Example
Console(config)#ip igmp snooping proxy-reporting
Console(config)#
ip igmp snooping
querier
This command enables the switch as an IGMP querier. Use the no form to disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General