Chapter 4
| System Management Commands
System Status
– 114 –
location-led This command flashes the Locator LED to indicate the unit to which you are
connected.
Syntax
location-led {on | off}
Command Mode
Privileged Exec
Command Usage
The Locator LED is labeled “Loc.” It is located in the upper right corner of the front
panel.
Example
Console#location-led on
Console#
show license file Shows information on the installed license file required for
the network ports
PE
show location-led status Shows if location LED function is enabled or not PE
show memory Shows memory utilization parameters NE, PE
show process cpu Shows CPU utilization parameters NE, PE
show running-config Displays the configuration data currently in use PE
show startup-config Displays the contents of the configuration file (stored in
flash memory) that is used to start up the system
PE
show system Displays system information NE, PE
show tech-support Displays a detailed list of system settings designed to help
technical support resolve configuration or functional
problems
PE
show users Shows all active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
NE, PE
show version Displays version information for the system NE, PE
show watchdog Shows if watchdog debugging is enabled PE
watchdog software Monitors key processes, and automatically reboots the
system if any of these processes are not responding
correctly
PE
Table 12: System Status Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General