Chapter 4
| System Management Commands
SMTP Alerts
– 160 –
logging sendmail This command enables SMTP event handling. Use the no form to disable this
function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#logging sendmail
Console(config)#
logging sendmail host This command specifies SMTP servers that will be sent alert messages. Use the no
form to remove an SMTP server.
Syntax
[no] logging sendmail host ip-address
ip-address - IPv4 or IPv6 address of an SMTP server that will be sent alert
messages for event handling.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ You can specify up to three SMTP servers for event handing. However, you must
enter a separate command to specify each server.
◆ To send email alerts, the switch first opens a connection, sends all the email
alerts waiting in the queue one by one, and finally closes the connection.
logging sendmail source-
email
Email address used for “From” field of alert messages GC
show logging sendmail Displays SMTP event handler settings NE, PE
Table 25: Event Logging Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General