Chapter 22
| Multicast Filtering Commands
MLD Snooping
– 618 –
ipv6 mld snooping This command enables MLD Snooping globally on the switch. Use the no form to
disable MLD Snooping.
Syntax
[no] ipv6 mld snooping
Default Setting
Disabled
Command Mode
Global Configuration
Example
The following example enables MLD Snooping:
Console(config)#ipv6 mld snooping
Console(config)#
ipv6 mld snooping
querier
This command allows the switch to act as the querier for MLDv2 snooping. Use the
no form to disable this feature.
Syntax
[no] ipv6 mld snooping querier
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
â—† If enabled, the switch will serve as querier if elected. The querier is responsible
for asking hosts if they want to receive multicast traffic.
â—† An IPv6 address must be configured on the VLAN interface from which the
querier will act if elected. When serving as the querier, the switch uses its own
IPv6 address as the query source address.
show ipv6 mld snooping
group source-list
Displays the learned groups and corresponding source list PE
show ipv6 mld snooping
mrouter
Displays the information of multicast router ports PE
Table 123: MLD Snooping Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General