Chapter 29
| IP Routing Commands
Global Routing Configuration
– 816 –
Example
Console(config)#hash-selection list 3 ipv6
Console(config-ipv4-hash-sel)#vlan
Console#
show ecmp
load-balance
This command shows the load-balance method used when there are multiple
equal-cost paths to the same destination.
Command Mode
Privileged Exec
Example
The default setting is shown in the following example.
Console#show ecmp load-balance
ECMP Load Balance Mode : Destination IP Address And L4 Port
Console#
show hash-selection
list
This command shows the packet type and hash list parameters.
Syntax
show hash-selection list [index]
index – Specifies the hash selection list to use for load balancing.
(Range: 1-4)
Command Mode
Privileged Exec
Command Usage
Field Selection attributes must all be matched for load balancing to be applied.
Example
Console#show hash-selection list 1
Hash-selection list 1
Packet type : MAC
Field selection : dst-mac src-mac ether-type vlan-id
Console#
To Next Page
Loading...
Need help?
General
