– 467 –
18 VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Table 90: VLAN Commands
Command Group Function
GVRP and Bridge Extension
Commands
Configures GVRP settings that permit automatic VLAN learning; shows
the configuration for bridge extension MIB
Editing VLAN Groups Sets up VLAN groups, including name, VID and state
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
Displaying VLAN
Information
Displays VLAN groups, status, port members, and MAC addresses
Configuring IEEE 802.1Q
Tunneling
Configures 802.1Q Tunneling (QinQ Tunneling)
Configuring L2CP
Tunneling
Configures Layer 2 Control Protocol (L2CP) tunneling, either by
discarding, processing, or transparently passing control packets across
a QinQ tunnel
Configuring VXLAN
Tunneling
Configures Virtual Extensible LAN (VXLAN) tunneling
To Next Page
Loading...
Need help?
General