EasyManuals Logo

Edge-Core AS5700-54X User Manual

Edge-Core AS5700-54X
1116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Chapter 1
| Initial Switch Configuration
Connecting to the Switch
– 59 –
An IPv4 address for the primary network interface is obtained via DHCP by default.
To manually configure this address or enable dynamic address assignment via
DHCP, see “Setting an IP Address” on page 62.
After configuring the switchs IP parameters, you can access the onboard
configuration program from anywhere within the attached network. The onboard
configuration program can be accessed using Telnet or SSH from any computer
attached to the network. The switch can also be managed by any computer using a
web browser (Internet Explorer 8 or above, Mozilla Firefox 32 or above, and Google
Chrome 39 or above).
Note:
This switch supports eight Telnet sessions or SSH sessions.
The onboard program only provides access to basic configuration functions. To
access the full range of SNMP management functions, you must use SNMP-based
network management software.
Obtaining and
Installing a License
for the Network Ports
The operational ports (that is network ports but not the craft port) are disabled by
default. These ports will only function when a port usage license is obtained from
your distributor and installed on the switch.
To verify whether or not a port usage license is installed on the switch, enter the
following command from the craft port. If the Link Down Reason displays “Invalid
or Trial License, then you need to obtain and install a license for the network ports.
Note that a trial licence limits the number of usable ports, whereas a valid license
provides full access to all ports.
Note:
A trial license provides access to ports 1-12 and 49-52 for one month.
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Member port of trunk 1 was created by user.
Port Type : 10GBASE SFP+
MAC Address : 70-72-CF-EA-1B-72
Configuration:
Port Admin : Up
Speed-duplex : 10G full
Capabilities : 10Gfull
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 500 packets/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 500 packets/second
Flow Control : Disabled
LACP : Disabled
MAC Learning : Enabled
Link-up-down Trap : Enabled
Media Type : None
MTU : 1518

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core AS5700-54X and is the answer not in the manual?

Edge-Core AS5700-54X Specifications

General IconGeneral
BrandEdge-Core
ModelAS5700-54X
CategorySwitch
LanguageEnglish

Related product manuals