Chapter 14
| Loopback Detection Commands
– 427 –
detect
- Sends an SNMP trap message when a loopback condition is
detected.
none
- Does not send an SNMP trap for loopback detection or recovery.
recover
- Sends an SNMP trap message when the switch recovers from a
loopback condition.
Default Setting
None
Command Mode
Global Configuration
Command Usage
Refer to the loopback-detection recover-time command for information on
conditions which constitute loopback recovery.
Example
Console(config)#loopback-detection trap both
Console(config)#
loopback-detection
release
This command releases all interfaces currently shut down by the loopback
detection feature.
Syntax
loopback-detection release
Command Mode
Privileged Exec
Example
Console#loopback-detection release
Console(config)#
To Next Page
Loading...
Need help?
General