Edge-Core AS5700-54X - Lldp

Chapter 23 | LLDP Commands
– 655 –
lldp This command enables LLDP globally on the switch. Use the no form to disable
LLDP.
Syntax
[no] lldp
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#lldp
Console(config)#
lldp holdtime-
multiplier
This command configures the time-to-live (TTL) value sent in LLDP advertisements.
Use the no form to restore the default setting.
Syntax
lldp holdtime-multiplier value
no lldp holdtime-multiplier
value - Calculates the TTL in seconds based on the following rule:
minimum of ((Transmission Interval * Holdtime Multiplier), or 65536)
(Range: 2 - 10)
Default Setting
Holdtime multiplier: 4
TTL: 4*30 = 120 seconds
Command Mode
Global Configuration
show lldp info
remote-device
Shows LLDP global and interface-specific
configuration settings for remote devices
PE
show lldp info statistics Shows statistical counters for all LLDP-enabled
interfaces
PE
* Vendor-specific options may or may not be advertised by neighboring devices.
Table 131: LLDP Commands (Continued)
Command Function Mode