Chapter 29
| IP Routing Commands
Border Gateway Protocol (BGPv4)
– 988 –
100-500 – Expanded community list number that identifies one or more
groups of communities.
community-list-name – Name of standard or expanded access list.
(Maximum length: 32 characters, no spaces or other special characters)
Command Mode
Privileged Exec
Example
Console#show ip extcommunity-list rd
Named extended community standard list rd
permit RT:192.168.0.0:10
Console#
show ip prefix-list This command shows the specified prefix list.
Syntax
show ip prefix-list [prefix-list-name [ip-address netmask [first-match | longer] |
seq sequence-number]]
prefix-list-name – Name of prefix list. (Maximum length: 128 characters, no
spaces or other special characters)
ip-address – An IPv4 address expressed in dotted decimal notation.
netmask – Network mask for the route. This mask identifies the network
address bits used for the associated routing entries.
first-match – First matched prefix.
longer – All entries more specific than the specified network/mask.
sequence-number – The sequence number of an entry.
(Range: 1-429496725)
Command Mode
Privileged Exec
Example
Console#show ip prefix-list rd
ip prefix-list rd: 1 entries
seq 5 deny 10.0.0.0/8 ge 14 le 22
Console#
To Next Page
Loading...
Need help?
General