Chapter 29
| IP Routing Commands
Policy-based Routing for BGP
– 999 –
match ip route-source This command specifies the source of routing messages advertised by routers and
access servers to be matched in a standard access list, an extended access list, or a
prefix list. Use the no form to remove this entry from a route map.
Syntax
match ip route-source {access-list-name | prefix-list prefix-list-name}
no match ip route-source [access-list-name | prefix-list]
access-list-name – Name of standard or extended access list.
(Maximum length: 32 characters, no spaces or other special characters)
prefix-list-name – Name of a specific prefix list.
Command Mode
Route Map
Command Usage
Note that there may be situations in which the next hop and source router address
of the route are not the same.
Example
Console(config)#route-map RD permit 6
Console(config-route-map)#match ip route-source rd-sources
Console(config-route-map)#set weight 30
Console(config-route-map)#
match metric This command sets the metric value to match in routing messages. Use the no form
to remove this entry from a route map.
Syntax
match metric metric-value
no match metric
metric-value – The metric value in the routing messages.
(Range: 0-4294967295)
Command Mode
Route Map
Example
Console(config)#route-map RD permit 7
Console(config-route-map)#match metric 60
Console(config-route-map)#set weight 30
Console(config-route-map)#
To Next Page
Loading...
Need help?
General