Chapter 23
| LLDP Commands
– 664 –
lldp dcbx-tlv
pfc-config
This command configures an LLDP-enabled port to advertise PFC configuration
settings. Use the no form to disable this feature.
Syntax
[no] lldp dcbx-tlv pfc-config
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ After enabling PFC on a switch interface (using the pfc mode command), DCBX
uses autonegotiation to control the operational state of the PFC functionality.
◆ If the peer is “willing” to learn its PFC configuration from the switch, DCBX
pushes the switch’s PFC configuration to the peer.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dcbx-tlv pfc-config
Console(config-if)#
lldp dot1-tlv
proto-ident
This command configures an LLDP-enabled port to advertise the supported
protocols. Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv proto-ident
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the protocols that are accessible through this interface.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-ident
Console(config-if)#
To Next Page
Loading...
Need help?
General