Chapter 29
| IP Routing Commands
Routing Information Protocol (RIP)
– 829 –
version This command specifies a RIP version used globally by the router. Use the no form
to restore the default value.
Syntax
version {1 | 2}
no version
1 - RIP Version 1
2 - RIP Version 2
Default Setting
Receive: Accepts RIPv1 or RIPv2 packets
Send: Route information is broadcast to other routers with RIPv2.
Command Mode
Router Configuration
Command Usage
â—† When this command is used to specify a global RIP version, any VLAN interface
not previously set by the ip rip receive version or ip rip send version command
will use the global RIP version setting.
â—† When the no form of this command is used to restore the default value, any
VLAN interface not previously set by the ip rip receive version or ip rip send
version command will be set to the default send or receive version.
â—† Any configured interface settings take precedence over the global settings.
Example
This example sets the global version for RIP to send and receive version 2 packets.
Console(config-router)#version 2
Console(config-router)#
Related Commands
ip rip receive version (831)
ip rip send version (833)
To Next Page
Loading...
Need help?
General