Chapter 22
| Multicast Filtering Commands
IGMP Filtering and Throttling
– 611 –
Example
This example shows how to enable IGMP Authentication on all of the switch’s
Ethernet interfaces.
Console(config)#interface ethernet 1/1-28
Console(config-if)#ip igmp authentication
Console#
Related Commands
show ip igmp authentication
ip igmp filter
(Interface Configuration)
This command assigns an IGMP filtering profile to an interface on the switch. Use
the no form to remove a profile from an interface.
Syntax
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
â—† The IGMP filtering profile must first be created with the ip igmp profile
command before being able to assign it to an interface.
â—† Only one profile can be assigned to an interface.
â—† A profile can also be assigned to a trunk interface. When ports are configured as
trunk members, the trunk uses the filtering profile assigned to the first port
member in the trunk.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#
NAS_PORT 5 User Port Number
FRAMED_IP_ADDRESS 8 Multicast Group ID
Table 122: IGMP Authentication RADIUS Attribute Value Pairs (Continued)
Attribute Name AVP Type Entry
To Next Page
Loading...
Need help?
General