Chapter 18
| VLAN Commands
Configuring VXLAN Tunneling
– 503 –
Console(config)#vxlan vlan 2 vni 1001
Console(config)#vxlan vlan 2 vni 1002
23:19:2: VXLAN: (1805) VLAN 2 is assigned to VNI 1001
Failed to associate VLAN 2 with VNI 1002.
Console(config)#
This example shows the type of debug information that would be to trace internal
VXLAN information on VTEP.
Console#debug vxlan vtep
Console#con
Console(config)#vxlan vni 1001 flood r-vtep 192.168.2.13
23:24:34: VXLAN: (2176) set rvtep ip[192.168.2.13]
l_vtep_ip[192.168.2.1]
dst_vid_ifindex [1003], dst_inet_addr[192.168.2.13]
vfi [28672], e_vlan[3], l3_if[6], lport[0], udp_port[4789]
mac[00:00:00:00:00:00]
23:24:34: VXLAN: (2398) vfi_id [0x7000], bcast_group[0xc000001], l3_if[6]
e_vlan[3], lport[0], udp_port[4789]
r_mac[00:00:00:00:00:00]
l_vtep[192.168.2.1], r_vtep[192.168.2.13], nexthop[192.168.2.13]
Console(config)#
show vxlan
udp-dst-port
This command shows the VXLAN UDP destination port.
Syntax
show vxlan udp-dst-port
Command Mode
Privileged Exec
Example
Console#show vxlan udp-dst-port
VXLAN UDP Destination Port: 4789
Console#
show vxlan vtep This command shows the remote VXLAN tunnel endpoint (VTEP).
Syntax
show vxlan vtep
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General