Chapter 11
| Link Aggregation Commands
Dynamic Configuration Commands
– 394 –
Example
The following shows LACP enabled on ports 1-3. Because LACP has also been
enabled on the ports at the other end of the links, the show interfaces status port-
channel 1 command shows that Trunk1 has been established.
Console(config)#interface ethernet 1/1-3
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic Information:
Port Type : 1000Base SFP
MAC Address : 12-34-12-34-12-3F
Configuration:
Name :
Port Admin : Up
Speed-duplex : 1000full
Capabilities : 1000full
Broadcast Storm : Enabled
Broadcast Storm Limit : 262143 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 262143 Kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 262143 Kbits/second
Flow Control : Disabled
VLAN Trunking : Disabled
MAC Learning : Enabled
MTU : 1518
Current status:
Created By : LACP
Link Status : Up
Port Operation Status : Up
Operation speed-duplex : 1000full
Up Time : 0w 0d 0h 14s (14 seconds)
Flow control Type : None
Max Frame Size : 1518 bytes (1522 bytes for tagged frames)
MAC Learning Status : Enabled
Member Ports : Eth1/1, Eth1/2, Eth1/3,
Active Member Ports : Eth1/1
Console#
lacp admin-key
(Ethernet Interface)
This command configures a port's LACP administration key. Use the no form to
restore the default setting.
Syntax
lacp {actor | partner} admin-key key
no lacp {actor | partner} admin-key
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
key - The port admin key must be set to the same value for ports that
belong to the same link aggregation group (LAG). (Range: 0-65535)
To Next Page
Loading...
