Chapter 7
| Authentication Commands
Secure Shell
– 233 –
Note:
The SSH server can be accessed using any configured IPv4 or IPv6 interface
address on the switch.
ip ssh authentication-
retries
This command configures the number of times the SSH server attempts to
reauthenticate a user. Use the no form to restore the default setting.
Syntax
ip ssh authentication-retries count
no ip ssh authentication-retries
count – The number of authentication attempts permitted after which the
interface is reset. (Range: 1-5)
Default Setting
3
Command Mode
Global Configuration
Example
Console(config)#ip ssh authentication-retires 2
Console(config)#
Related Commands
show ip ssh (238)
ip ssh server This command enables the Secure Shell (SSH) server on this switch. Use the no
form to disable this service.
Syntax
[no] ip ssh server
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆ The SSH server supports up to four client sessions. The maximum number of
client sessions includes both current Telnet sessions and SSH sessions.
To Next Page
Loading...
