Chapter 20
| Quality of Service Commands
– 541 –
service-policy This command applies a policy map defined by the policy-map command to the
ingress or egress side of a particular interface. Use the no form to remove this
mapping.
Syntax
[no] service-policy {input | output} policy-map-name
input
- Apply to the input traffic.
output - Apply to the output traffic.
policy-map-name
- Name of the policy map for this interface.
(Range: 1-32 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
First define a class map, then define a policy map, and finally use the service-policy
command to bind the policy map to the required interface.
Example
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd-policy
Console(config-if)#
show class-map This command displays the QoS class maps which define matching criteria used for
classifying traffic.
Syntax
show class-map [class-map-name]
class-map-name - Name of the class map. (Range: 1-32 characters)
Default Setting
Displays all class maps.
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General