Chapter 11
| Link Aggregation Commands
MLAG Commands
– 407 –
â–
When an MLAG member is operationally down, all updates for learned MAC
addresses on the MLAG peer member will be synced through the peer link
automatically.
Figure 2: MLAG Peer Operation
â—† When the MLAG peer member is down or nonexistent, learned MAC addresses
are synced through the peer link for the MLAG will be removed automatically.
Example
Console(config)#mlag group 1 domain 1 member ethernet 1/1
Console(config)#
show mlag This command shows MLAG configuration settings.
Command Mode
Privileged Exec
Example
Console#show mlag
Global Status : Enabled
Domain List : 1,2
MLAG List : 10,20,30-35,50
Console#
show mlag domain The command shows MLAG domain settings.
Command Mode
Privileged Exec
Syntax
show mlag domain domain-id
domain-id – Domain identifier. (Range: 1-16 characters)
To Next Page
Loading...
Need help?
General