Chapter 29
| IP Routing Commands
Global Routing Configuration
– 803 –
IPv4 Commands
ip route This command configures static routes. Use the no form to remove static routes.
Syntax
ip route destination-ip netmask next-hop [distance]
no ip route {destination-ip netmask next-hop | *}
destination-ip – IP address of the destination network, subnetwork, or host.
netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
next-hop – IP address of the next hop router used for this route.
distance – An administrative distance indicating that this route can be
overridden by dynamic routing information if the distance of the dynamic
route is less than that configured for the static route. Note that the default
administrative distances used by the dynamic unicast routing protocols is
110 for OSPF, 120 for RIP, 20 for eBGP, and 200 for iBGP. (Range: 1-255,
Default: 1)
* – Removes all static routing table entries.
Default Setting
No static routes are configured.
Command Mode
Global Configuration
Command Usage
â—† Up to 512 static routes can be configured.
â—† Up to eight equal-cost multipaths (ECMP) can be configured for static routing
using the maximum-paths command.
â—† If an administrative distance is defined for a static route, and the same
destination can be reached through a dynamic route at a lower administration
distance, then the dynamic route will be used.
show ecmp load-balance Shows the load-balance method used when there are
multiple equal-cost paths to the same destination
PE
show hash-selection list Shows the packet type and hash list attributes PE
1 MAC HS – MAC hash selection.
2 IPv4 HS – IPv4 hash selection.
3 IPv6 HS – IPv6 hash selection
Table 164: Global Routing Configuration Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General