Chapter 5
| SNMP Commands
SNMP Target Host Commands
– 189 –
â—† If you specify an SNMP Version 3 host, then the community string is interpreted
as an SNMP user name. The user name must first be defined with the snmp-
server user command. Otherwise, an SNMPv3 group will be automatically
created by the snmp-server host command using the name of the specified
community string, and default settings for the read, write, and notify view.
Example
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands
snmp-server enable traps (186)
snmp-server
enable port-traps
mac-notification
This command enables the device to send SNMP traps (i.e., SNMP notifications)
when a dynamic MAC address is added or removed. Use the no form to restore the
default setting.
Syntax
[no] snmp-server enable port-traps mac-notification
mac-notification - Keyword to issue trap when a dynamic MAC address is
added or removed.
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command can enable MAC authentication traps on the current interface only if
they are also enabled at the global level with the snmp-server enable traps mac-
authentication command.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps mac-notification
Console(config)#
To Next Page
Loading...
Need help?
General