Chapter 23
| LLDP Commands
– 659 –
Command Usage
â—† The transmit delay is used to prevent a series of successive LLDP transmissions
during a short period of rapid changes in local LLDP MIB objects, and to
increase the probability that multiple, rather than single changes, are reported
in each transmission.
â—† This attribute must comply with the following rule:
(4 * tx-delay) ≤
refresh-interval
Example
Console(config)#lldp tx-delay 10
Console(config)#
lldp admin-status This command enables LLDP transmit, receive, or transmit and receive mode on the
specified port. Use the no form to disable this feature.
Syntax
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#
lldp basic-tlv
management-ip-
address
This command configures an LLDP-enabled port to advertise the management
address for this device. Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv management-ip-address
Default Setting
Enabled
To Next Page
Loading...
Need help?
General