Chapter 10
| Interface Commands
Interface Configuration
– 367 –
Example
The following example clears statistics on port 5.
Console#clear counters ethernet 1/5
Console#
hardware profile
portmode
This command configures port settings for 40G operation.
Syntax
hardware profile portmode interface {1x40g | 4x10g | reset}
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
1x40g - Configures the port as a single 40G port.
4x10g - Configures the port as four 10G ports.
reset - Configures port mode to the default setting.
Default Setting
AS6700-32X: 1x40g
AS6700-54X: The example under the show hardware profile portmode command
shows the default settings for this switch.
Command Mode
Privileged Exec
Command Usage
â—† 40G ports can be configured as a single port connected with 40G QSFP fiber
cable, 40G DAC (direct attach) cable, or breakout cable that connects a 40G port
to four 10G ports. Refer to the installation Guide for more information on how to
use these cable types.
â—† Four 10G ports can also be configured as a single 40G port using breakout
cable. Refer to the installation Guide for more information on how to use this
cabling option.
Example
This example is for the AS6700-32X, affecting only Port 1.
Console#hardware profile portmode ethernet 1/1 4x10g
Console#
To Next Page
Loading...
Need help?
General