Chapter 16
| Address Table Commands
– 438 –
mac-address-table
static
This command maps a static address to a port in a VLAN, and optionally designates
the address as permanent, or to be deleted on reset. Use the no form to remove an
address.
Syntax
mac-address-table static mac-address interface interface vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
mac-address - MAC address.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
vlan-id - VLAN ID (Range: 1-4094)
action -
delete-on-reset - Assignment lasts until the switch is reset.
permanent - Assignment is permanent.
Default Setting
No static addresses are defined.
The default lifetime is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port within a
specific VLAN. Use this command to add static addresses to the MAC Address Table.
Static addresses have the following characteristics:
â—† Static addresses will not be removed from the address table when a given
interface link is down.
â—† Static addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be ignored
and will not be written to the address table.
â—† A static address cannot be learned on another port until the address is removed
with the no form of this command.
To Next Page
Loading...
Need help?
General