Edge-Core AS5700-54X - Dot1 X Timeout Re-Authperiod

Chapter 7 | Authentication Commands
802.1X Port Authentication
– 247 –
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
dot1x timeout
re-authperiod
This command sets the time period after which a connected client must be re-
authenticated. Use the no form of this command to reset the default.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
dot1x timeout
supp-timeout
This command sets the time that an interface on the switch waits for a response to
an EAP request from a client before re-transmitting an EAP packet. Use the no form
to reset to the default value.
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds