Chapter 29
| IP Routing Commands
Global Routing Configuration
– 806 –
Example
In the following example, note that the entry for RIP displays both the distance and
metric for this route.
Console#show ip route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default
R 10.1.1.0/24 [120/2] via 192.168.1.10, VLAN1, 00:00:14
C 127.0.0.0/8 is directly connected, lo
C 192.168.1.0/24 is directly connected, VLAN1
Console#
show ip route
database
This command displays entries in the Routing Information Base (RIB).
Command Mode
Privileged Exec
Command Usage
The RIB contains all available routes learned through dynamic routing protocols,
directly attached networks, and any additionally configured routes such as static
routes. The RIB contains the set of all available routes from which optimal entries
are selected for use by the Forwarding Information Base (see Command Usage
under the show ip route command).
Example
Console#show ip route database
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
> - selected route, * - FIB route, p - stale info
C *> 127.0.0.0/8 is directly connected, lo0
C *> 192.168.1.0/24 is directly connected, VLAN1
Console#
To Next Page
Loading...
Need help?
General