Chapter 23
| LLDP Commands
– 656 –
Command Usage
â—† The time-to-live tells the receiving LLDP agent how long to retain all
information pertaining to the sending LLDP agent if it does not transmit
updates in a timely manner.
â—† If the local interface attached to a remote device is shut down or otherwise
disabled, information about the remote device is purged immediately.
Example
Console(config)#lldp holdtime-multiplier 10
Console(config)#
lldp med-fast-start-
count
This command specifies the amount of MED Fast Start LLDPDUs to transmit during
the activation process of the LLDP-MED Fast Start mechanism.
Syntax
lldp med-fast-start-count packets
no lldp med-fast-start-count
seconds - Amount of packets. (Range: 1-10 packets; Default: 4 packets)
Default Setting
4 packets
Command Mode
Global Configuration
Command Usage
This parameter is part of the timer which ensures that the LLDP-MED Fast Start
mechanism is active for the port. LLDP-MED Fast Start is critical to the timely
startup of LLDP, and therefore integral to the rapid availability of Emergency Call
Service.
Example
Console(config)#lldp med-fast-start-count 6
Console(config)#
To Next Page
Loading...
Need help?
General