Chapter 19
| Class of Service Commands
Priority Commands (Layer 2)
– 509 –
â—† Service time is shared at the egress ports by defining scheduling weights for
WRR, or for the queuing mode that uses a combination of strict and weighted
queuing. Service time is allocated to each queue by calculating a precise
number of bytes per second that will be serviced on each round.
â—† The specified queue mode applies to all interfaces.
Example
The following example sets the queue mode to strict priority service mode:
Console(config)#queue mode strict
Console(config)#
Related Commands
queue weight (509)
show queue mode (511)
queue weight This command assigns weights to the eight class of service (CoS) priority queues
when using weighted queuing, or one of the queuing modes that use a
combination of strict and weighted queuing. Use the no form to restore the default
weights.
Syntax
queue weight weight0...weight7
no queue weight
weight0...weight7 - The ratio of weights for queues 0 - 7 determines the
weights used by the WRR scheduler. (Range: 1-15)
Default Setting
Weights 1, 2, 4, 6, 8, 10, 12, 14 are assigned to queues 0 - 7 respectively.
Command Mode
Interface Configuration (Ethernet)
Command Usage
â—† This command shares bandwidth at the egress port by defining scheduling
weights for WRR, or for the queuing mode that uses a combination of strict and
weighted queuing (page 508).
â—† Bandwidth is allocated to each queue by calculating a precise number of bytes
per second that will be serviced on each round.
To Next Page
Loading...
Need help?
General