Chapter 4
| System Management Commands
Time Range
– 180 –
Default Setting
None
Command Mode
Time Range Configuration
Command Usage
â—† If a time range is already configured, you must use the no form of this
command to remove the current entry prior to configuring a new time range.
â—† If both an absolute rule and one or more periodic rules are configured for the
same time range (i.e., named entry), that entry will only take effect if the current
time is within the absolute time range and one of the periodic time ranges.
Example
This example configures a time range for the periodic occurrence of an event.
Console(config)#time-range sales
Console(config-time-range)#periodic daily 1 1 to 2 1
Console(config-time-range)#
show time-range This command shows configured time ranges.
Syntax
show time-range [name]
name - Name of the time range. (Range: 1-30 characters)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show time-range r&d
Time-range r&d:
absolute start 01:01 01 April 2009
periodic Daily 01:01 to Daily 02:01
periodic Daily 02:01 to Daily 03:01
Console#
To Next Page
Loading...
Need help?
General