Chapter 10
| Interface Commands
Interface Configuration
– 363 –
back pressure is used for half-duplex operation and IEEE 802.3-2002 (formally
IEEE 802.3x) for full-duplex operation.
Example
The following example enables flow control on port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#
history This command configures a periodic sampling of statistics, specifying the sampling
interval and number of samples. Use the no form to remove a named entry from
the sampling table.
Syntax
history name interval buckets
no history name
name - A symbolic name for this entry in the sampling table. (Range: 1-32
characters)
interval - The interval for sampling statistics. (Range: 1-86400 seconds)
buckets - The number of samples to take. (Range: 1-96)
Default Setting
15min - 15 minute interval, 96 buckets
1day - 1 day interval, 7 buckets
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
This example sets a interval of 15 minutes for sampling standard statisical values on
port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#history 15min 15 10
Console(config-if)#
To Next Page
Loading...
