Chapter 7
| Authentication Commands
Web Server
– 226 –
Related Commands
ip http port (225)
show system (120)
ip http secure-port This command specifies the UDP port number used for HTTPS connection to the
switch’s web interface. Use the no form to restore the default port.
Syntax
ip http secure-port port-number
no ip http secure-port
port-number – The TCP port used for HTTPS. (Range: 1-65535, except for the
following reserved ports: 1 and 25 - Linux kernel, 23 - Telnet, 80 - HTTP)
Default Setting
443
Command Mode
Global Configuration
Command Usage
â—† You cannot configure the HTTP and HTTPS servers to use the same port.
â—† If you change the HTTPS port number, clients attempting to connect to the
HTTPS server must specify the port number in the URL, in this format: https://
device:port_number
Example
Console(config)#ip http secure-port 1000
Console(config)#
Related Commands
ip http secure-server (226)
show system (120)
ip http secure-server This command enables the secure hypertext transfer protocol (HTTPS) over the
Secure Socket Layer (SSL), providing secure access (i.e., an encrypted connection)
to the switch’s web interface. Use the no form to disable this function.
Syntax
[no] ip http secure-server
Default Setting
Enabled
To Next Page
Loading...
Need help?
General