Chapter 7
| Authentication Commands
Web Server
– 224 –
Example
Console(config)#tacacs-server timeout 10
Console(config)#
show tacacs-server This command displays the current settings for the TACACS+ server.
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show tacacs-server
Remote TACACS+ Server Configuration:
Global Settings:
Server Port Number : 49
Retransmit Times : 2
Timeout : 5
Server 1:
Server IP Address : 10.11.12.13
Server Port Number : 49
Retransmit Times : 2
Timeout : 4
TACACS+ Server Group:
Group Name Member Index
------------------------- -------------
tacacs+ 1
Console#
Web Server
This section describes commands used to configure web browser management
access to the switch.
Table 41: Web Server Commands
Command Function Mode
ip http port Specifies the port to be used by the web browser interface GC
ip http server Allows the switch to be monitored or configured from a
browser
GC
ip http secure-port Specifies the UDP port number for HTTPS GC
ip http secure-server Enables HTTPS (HTTP/SSL) for encrypted communications GC
To Next Page
Loading...
Need help?
General