Chapter 10
| Interface Commands
Interface Configuration
– 360 –
Interface Configuration
interface This command configures an interface type and enters interface configuration
mode. Use the no form with a trunk to remove an inactive interface.
Syntax
[no] interface interface-list
interface-list – One or more ports. Use a hyphen to indicate a
consecutive
list of ports or a comma between non-consecutive ports.
craft - Management port on the front panel.
ethernet unit/port-list
unit - Unit identifier. (Range: 1)
port-list - Physical port number or list of port numbers. Separate
nonconsecutive port numbers with a comma and no spaces; or use
a hyphen to designate a range of port numbers. (Range: 1-32/54)
port-channel channel-id (Range: 1-27)
vlan vlan-id (Range: 1-4094)
Default Setting
None
Command Mode
Global Configuration
transceiver-threshold
rx-power
Sets thresholds for the transceiver power level of the
received signal which can be used to trigger an alarm or
warning message
IC
transceiver-threshold
temperature
Sets thresholds for the transceiver temperature which can
be used to trigger an alarm or warning message
IC
transceiver-threshold
tx-power
Sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or
warning message
IC
transceiver-threshold
voltage
Sets thresholds for the transceiver voltage which can be
used to trigger an alarm or warning message
IC
show interfaces transceiver Displays the temperature, voltage, bias current, transmit
power, and receive power
PE
show interfaces transceiver-
threshold
Displays the alarm/warning thresholds for temperature,
voltage, bias current, transmit power, and receive power
PE
Cable Diagnostics
test loop internal Performs an internal loop back test on the specified port PE
show loop internal Shows the results of a loop back test PE
Table 69: Interface Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General