Chapter 24
| CFM Commands
Link Trace Operations
– 712 –
Example
This example sets the aging time for entries in the link trace cache to 60 minutes.
Console(config)#ethernet cfm linktrace cache hold-time 60
Console(config)#
ethernet cfm linktrace
cache size
This command sets the maximum size for the link trace cache. Use the no form to
restore the default setting.
Syntax
ethernet cfm linktrace cache size entries
entries – The number of link trace responses stored in the link trace cache.
(Range: 1-4095 entries)
Default Setting
100 entries
Command Mode
Global Configuration
Command Usage
â—† Before setting the cache size, the cache must first be enabled with the ethernet
cfm linktrace cache command.
â—† If the cache reaches the maximum number of specified entries, or the size is set
to a value less than the current number of stored entries, no new entries are
added. To add additional entries, the cache size must first be increased with this
command, or purged with the clear ethernet cfm linktrace-cache command.
Example
This example limits the maximum size of the link trace cache to 500 entries.
Console(config)#ethernet cfm linktrace cache size 500
Console(config)#
ethernet cfm linktrace This command sends CFM link trace messages to the MAC address of a remote MEP.
Syntax
ethernet cfm linktrace {dest-mep destination-mpid | src-mep source-mpid
{dest-mep destination-mpid | mac-address} | mac-address} md domain-name
ma ma-name [ttl number]
destination-mpid – The identifier of a remote MEP that is the target of the
link trace message. (Range: 1-8191)
To Next Page
Loading...
Need help?
General