Chapter 29
| IP Routing Commands
Open Shortest Path First (OSPFv3)
– 904 –
show ipv6 ospf
neighbor
This command displays information about neighboring routers on each interface
within an OSPF area.
Syntax
show ipv6 ospf [tag process-id] neighbor
process-id - The ID of the router process for which information will be
displayed. (Range: 1-10)
Command Mode
Privileged Exec
Router ID Identifier for this router
Network Type Includes broadcast, non-broadcast, or point-to-point networks
Cost Interface transmit cost
Transmit Delay Interface transmit delay (in seconds)
State
â—†
Backup – Backup Designated Router
â—†
Down – OSPF is enabled on this interface, but interface is down
â—†
DR – Designated Router
â—†
DROther – Interface is on a multiaccess network, but is not the DR or BDR
â—†
Loopback – This is a loopback interface
â—†
PointToPoint – A direct link between two routers.
â—†
Waiting – Router is trying to find the DR and BDR
Priority Router priority
Designated
Router
Designated router ID and respective interface address
Backup
Designated
Router
Backup designated router ID and respective interface address
Timer intervals Configuration settings for timer intervals, including Hello, Dead and Retransmit
Neighbor Count Count of network neighbors and adjacent neighbors
Hello Number of Hello LSAs received and sent
DD Number of Database Descriptor packets received and sent
LS-Req Number of LSA requests
LS-Upd Number of LSA updates
LS-Ack Number of LSA acknowledgements
Discarded Number of LSAs discarded
Table 182: show ip ospf interface - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General