Chapter 4
| System Management Commands
File Management
– 135 –
Hash value: 185b962f
Verifying Hash Integrity ... crc32+ OK
....
pci 0000:00:00.0: ignoring class b20 (doesn't match header type 01)
Info: Mounting kernel filesystems... done.
Info: Using eth0 MAC address: 00:11:22:33:44:55
Info: eth0: Checking link... scsi 0:0:0:0: Direct-Access
USB DISK 2.0 PMAP PQ: 0 ANSI: 0 CCS
sd 0:0:0:0: [sda] 3911680 512-byte logical blocks: (2.00 GB/1.86 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] No Caching mode page present
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] No Caching mode page present
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] No Caching mode page present
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Attached SCSI disk up.
Info: Trying DHCPv4 on interface: eth0
DHCPv4 on interface: eth0 failedONIE:
Using default IPv4 addr: eth0: 192.168.3.10/255.255.255.0
Starting: dropbear ssh daemon... done.
Starting: telnetd... done.
discover: Rescue mode detected. Installer disabled.
Please press Enter to activate this console.
To check the install status inspect /var/log/onie.log.
Try this: tail -f /var/log/onie.log
** Rescue Mode Enabled **
ONIE:/ #
ONIE:/ # ifconfig eth0 192.168.1.1 netmask 255.255.255.0
3. Use the "install_url" command to install the AOS runtime image through ONIE
rescue mode. Device will be automatically restarted and tje AOS runtime will be
booted up after the installation succeeds. Please manually power off and on
the device if you see tje console is freeze like below.
ONIE:/ # install_url tftp://192.168.1.20/
AOS5700-54X_V0.0.1.13_EC.installer
Stopping: discover... done.
Info: Fetching tftp://192.168.1.20/AOS5700-54X_V0.0.1.0.installer ...
runtime.installer 100% |*******************************| 24751k
0:00:00 ETA
ONIE: Executing installer: tftp://192.168.1.20/
AOS5700-54X_V0.0.1.0.installer
Verifying image checksum ... OK.
Preparing image archive ... OK.
support_machines="as5700_54x"
runtime_image_name=runtime.bix
Installer: support_machines: as5700_54x
edgecore_as5610_54x
Match found!(as5610_54x)
Partition layout is the same as expected.
Install Image