Chapter 2
| Using the Command Line Interface
CLI Command Groups
– 94 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
DC (DHCP Server Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
PM (Policy Map Configuration)
RC (Router Configuration)
RM (Route Map Configuration)
VC (VLAN Database Configuration)
Quality of Service Configures Differentiated Services 527
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router
581
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
653
Domain Name Service Configures DNS services. 723
Dynamic Host
Configuration Protocol
Configures DHCP client, relay and server functions 733
Router Redundancy Configures router redundancy to create primary and backup
routers
791
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
741
IP Routing Configures static unicast routing, policy-based unicast
routing for BGP, and dynamic unicast routing
801
Multicast Routing Configures static multicast routing for IPv4 1013
Data Center Configures Database Center Bridging Exchange (DCBX),
Congestion Notification (CN), Enhanced Transmission
Selection (ETS), Priority-Based Flow Control (PFC), and
OpenFlow
545
Debug Displays debugging information for all key function
These commands are not described in this manual
Please refer to the prompt messages included in the CLI interface.
Table 7: Command Group Index (Continued)
Command Group Description Page
To Next Page
Loading...
Need help?
General