Enterasys Matrix E1 1G694-13 User Manual

Matrix E1 CLI Quick Reference Guide
CLI Tasks, Commands and Syntax
Matrix E1 Series (1G694-13) Configuration Guide A-5
IP address (show)
Displays the local host port IP address and the system mask. For
details, refer to Section 3.2.2.10.
show ip address
IP route (clear)
Deletes IP routing table entries. For details, refer to Section 9.2.3.6.
clear ip route gateway
IP route (set)
Adds IP addresses to the device’s IP routing table. For details, refer to
Section 9.2.3.5.
set ip route gateway
IP route (show)
Displays the device’s IP routing table entries. For details, refer to
Section 9.2.3.4.
show ip route
jumbo frame support
(set)
Displays the status of jumbo frame support on the device. For details,
refer to Section 4.2.5.1.
show jumbo
jumbo frame support
(show)
Enables or disables jumbo frame support on the device. For details,
refer to Section 4.2.5.2.
set jumbo {enable | disable}
MAC (clear)
Deletes dynamic MAC address information for the device. For
details, refer to Section 9.2.3.8.
clear mac
MAC (show)
Displays MAC addresses contained in the device’s source address
table. For details, refer to Section 9.2.3.7.
show mac [address mac address] [fid vlan_id ] [port port_string]
[type {learned | self | mgmt}]
mirroring (set port)
Enables or disables mirroring between two ports. For details, refer to
Section 4.2.8.2.
set port mirroring [port_string port_string] {disable | enable}
CLI Task Command Function and Syntax

Enterasys Matrix E1 1G694-13 Specifications

General

Brand	Enterasys
Model	Matrix E1 1G694-13
Category	Switch
Language	English