Matrix E1 CLI Quick Reference Guide
CLI Tasks, Commands and Syntax
A-10 Matrix E1 Series (1G694-13) Configuration Guide
Spanning Tree port
priority (set)
Sets a port’s priority for use in the Spanning Tree algorithm (STA). For
details, refer to Section 5.2.2.4.
set spantree portpri port_string priority
Spanning Tree port
priority (show)
Displays the Spanning Tree priority for one or more ports. For details,
refer to Section 5.2.2.3.
show spantree portpri port_string
Spanning Tree port
status (set)
Enables or disables the Spanning Tree algorithm (STA) on one or more
ports. For details, refer to Section 5.2.2.1.
set spantree portadmin port_string {enable | disable}
Spanning Tree priority
(set)
Sets the device’s Spanning Tree priority. The lower the numeric value,
the higher the device priority. For details, refer to Section 5.2.1.5.
set spantree priority bridge_priority
Spanning Tree real time
message age (set)
Enables or disables real time BPDU message age mode. For details,
refer to Section 5.2.1.16.
set spantree rtmsgage {enable | disable}
Spanning Tree real time
message age (show)
Displays the status of real time BPDU message age mode. For details,
refer to Section 5.2.1.15.
show spantree rtmsgage
Spanning Tree transmit
hold count (set)
Sets the maximum transmit hold count on a Spanning Tree. This is the
number of BPDUs which will be transmitted before transmissions are
subject to a one-second timer. For details, refer to Section 5.2.1.18.
set spantree txholdcount txholdcount
Spanning Tree transmit
hold count (show)
Displays the maximum BPDU transmission rate. For details, refer to
Section 5.2.1.17.
show spantree txholdcount
Spanning Tree topology
change trap suppress
(set)
Disables or enables topology change trap suppression on Rapid
Spanning Tree edge ports. When enabled, this prevents edge ports
from sending topology change traps. For details, refer to
Section 5.2.1.14.
set spantree tctrapsuppress {disable | enable}
CLI Task Command Function and Syntax
To Next Page
Loading...
Need help?
General